
1.
What's included in the box: TT25 Extended Battery Base unit, Standard Flex Band, Collar Strap, Collar Charging Clip, USB-C cable, Rubber Antenna Keeper, Short and Long Contact Point Sets with Wrench.
NOTE: You will need a small Phillips screwdriver.

2. Remove the TT25 Extended Base Unit from the box.

3. Remove the Standard Flex Band and two Phillips-head screws from the box.

4. Attach the Standard Flex Band to the TT25 Extended Base Unit using the two Phillips-head screws.

5. Install the collar strap in the TT25 Base Unit strap holders, then through the Standard Flex Band.

6. Place the rubber keeper between the base unit and the square piece at the end of the Flex band so that the keeper holds the strap. Then run the antenna through the slots on the rubber keeper.

7. Your collar is now ready to use.