
1.
What's included in the box: TT25 Base unit, Zero Flex Band, Collar Strap, Collar Charging Clip, USB-C cable, Short and Long Contact Point Sets with Wrench, Rubber Antenna Keeper (not used).
NOTE: You will need a small Phillips screwdriver.

2. Remove the TT25 Base Unit from the box.

3. Remove the Zero Flex Band, three plastic antenna clips, and two Phillips-head screws from the box.

4. Attach the Zero Flex Band to the TT25 Base Unit using the two Phillips-head screws.

5. Install the collar strap in the TT25 Base Unit strap holders, then through the Zero Flex Band.

6. Install the three antenna clips on the end of the collar strap and snap the VHF antenna on them.

7. Your collar is now ready to use. NOTE: You will not use the rubber antenna keeper on the TT25 MINI collar.