Instructions for 2-dog systems are below. Please read all steps before starting.One Dog Systems:
1. Turn the transmitter on by pushing the ON/OFF Button located on the right side.
2. Set the Intensity Selection Dial to "0".
3. Starting with the receiver/collar turned OFF, place the two red dots together for 5 seconds. The LED on the receiver/collar will rapidly blink green when successfully in code setting mode. Once in code setting mode, separate the receiver/collar and the handheld transmitter.
4. While the LED on the receiver/collar is rapidly blinking, press the two gray buttons together on the handheld transmitter. The code setting is complete when the LED on the receiver/collar blinks every 5 seconds. The gray buttons will now control the receiver/collar.
Two Dog Systems:
1. Turn the transmitter on by pushing the ON/OFF Button located on the right side.
2. Set the Intensity Selection Dial to "0".
3. Starting with the receiver/collar turned OFF, place the two red dots together for 5 seconds. The LED on the receiver/collar will rapidly blink green when successfully in code setting mode. Once in code setting mode, separate the receiver/collar and the handheld transmitter.
4. While the LED on the receiver/collar is rapidly blinking, press the two orange buttons together on the handheld transmitter. The code setting is complete when the LED on the receiver/collar blinks every 5 seconds. The orange buttons will now control the orange receiver/collar and the gray buttons will control the black receiver/collar. Pressing a button on the handheld transmitter will activate the LED on the corresponding receiver/collar.
